POPS · portable outdoor power station

Power you carry to the work

From 300 W up to 3 kW of output and as much as 4 kWh of usable energy, in a sealed case with a handle. AC sockets, DC outputs and USB on the front; a solar input on the side, so it recharges wherever it is standing.

An ENA portable outdoor power station on open ground at sunrise, connected to two banks of ENA solar panels

Specification

One case, the whole supply

Inverter, battery, charge controller and outputs in a single enclosure, so there is nothing to wire up on arrival. Charge it from a panel, from a socket or from a vehicle; run tools, lighting, a fridge or a laptop off it.

Output300 W – 3 kW, by model
Usable energyUp to 4 kWh
OutputsAC sockets, DC outputs, USB
ChargingSolar input, mains, vehicle
BuildSealed case, carry handles, outdoor duty

Where they go

Built to be taken outdoors, not to sit in a plant room

A POPS is specified for the places a fixed installation cannot reach: the site before the supply arrives, the boat, the field station, the outage.

An ENA POPS portable power station strapped to the deck rail of a small boat under a clear sky
An ENA POPS portable power station standing in deep snow in bright sunlight, its display visible

Work sites

Tools and lighting on a site that has no supply yet, without a generator, a fuel can or the noise.

Marine and field

Sealed against spray and dust, charged off a panel on deck or on the roof of a vehicle.

Cold and heat

Specified to keep working at the temperature extremes where a cheap pack simply shuts down.

Outage cover

A fridge, a router and lighting through an outage, with nothing to install in advance.

Clinics and cold chain

Vaccine refrigeration and diagnostics kept running where the grid cannot be relied on.

Events and media

Quiet power for stalls, stages and camera kit where a generator is not acceptable.

An ENA POPS portable power station on a workshop floor, showing its wide front display panel, carry handles and the ENA logo

Supply

Single units, fleets, and distribution

POPS are supplied as single units, as fleets for field teams and clinics, and to distributors. Local assembly is part of the manufacturing programme, so fleet orders are not waiting on a container.